Anycubic Water-Wash Resin 2.0 1kg – Grey

Anycubic Water-Wash Resin 2.0 cleans up with plain water instead of isopropyl alcohol, which takes the cost and the fumes of an IPA wash out of post-processing. Grey shows fine detail clearly and is the standard choice for miniatures and prototypes you plan to prime and paint.

It is a 365–405 nm photopolymer with a low viscosity of 190–230 mPa·s at 25 °C, so it flows back under the build plate quickly and suits fast layer times. Volume shrinkage is 2.2–5.5%, hardness 82–85 HD, tensile strength 38–43 MPa and elongation at break 16–22%. Wash prints in water for at least five minutes, then post-cure under 405 nm UV for around three minutes.

It works with Anycubic Photon printers including the P1, Mono M7, Mono M5, Mono 4 and Mono X series, and with other 405 nm LCD and DLP resin printers. Rinse water contains uncured resin: cure it in sunlight or under UV before disposal, never pour it down the drain, and wear nitrile gloves when handling liquid resin.